Skip to content
Guide

How to Clean Glassy Carbon and Platinum Electrodes

Polish a glassy carbon electrode on a wet cloth with alumina slurry, then rinse it well. Clean a platinum electrode by rinsing it, then soaking it in dilute acid or cycling it in dilute sulfuric acid. Keep the tip of an Ag/AgCl reference electrode in its filling solution. Where your own protocol differs, follow your protocol.

How to clean a glassy carbon electrode

  • Wet a polishing cloth on a flat surface and add a little alumina slurry.
  • Move the electrode in a figure of eight, holding it upright with light, even pressure.
  • Work down in grit if the surface is scratched, for example from 1 µm to 0.3 µm and then 0.05 µm alumina.
  • Rinse well with deionised water, so that no alumina stays on the surface.
  • If the body allows it, sonicate briefly in deionised water or ethanol, then rinse again.
  • Check the surface with a cyclic voltammogram of a known redox couple, such as ferricyanide.

How to clean a platinum electrode

The same steps suit platinum wire, mesh, sheet and disk counter or working electrodes, except that only a disk is polished.

  • Rinse with deionised water to remove electrolyte.
  • For light contamination, soak in dilute nitric acid, then rinse well.
  • For an electrochemically clean surface, cycle the potential in dilute sulfuric acid until the voltammogram stops changing.
  • Flame cleaning suits bare platinum only. Never flame an electrode with a PTFE or PEEK body.

How to store an Ag/AgCl reference electrode

  • Keep the tip in a storage solution that matches the filling solution, usually KCl of the same strength.
  • Do not store it in deionised water: chloride leaches out and the potential drifts.
  • Never let the junction dry out. Top up the filling solution when the level drops.
  • Check it now and then against a reference electrode kept only for that purpose.
  • The reference electrode care guide gives the filling solution for every type, and how to refill and test one.

Cleaning at a glance

How to clean common electrodes
ElectrodeClean withAvoid
Glassy carbonAlumina slurry on a polishing clothCoarse abrasives and leaving alumina on the surface
PlatinumRinsing, dilute acid, or cycling in dilute sulfuric acidBending thin wire or mesh, and flame on polymer bodies
GoldAlumina polish, then cycling in dilute sulfuric acidHard scrubbing: gold is soft
Ag/AgClRinse the outside only, and refresh the filling solutionDrying out and storing in deionised water

Frequently asked questions

How often should I polish a glassy carbon electrode?

Before each experiment, or whenever the voltammogram changes shape. A fouled surface shows up as wider peak separation and lower peak current.

Can I clean a platinum counter electrode with acid?

Yes. Dilute nitric acid is a common choice, and cycling in dilute sulfuric acid is the usual way to get an electrochemically clean surface.

See also